EasyManuals Logo

Metrohm 756 KF User Manual

Metrohm 756 KF
163 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
4.1 General rules
756/831 KF Coulometer, Instructions for Use
58
RS send errors:
E42 CTS=OFF No proper handshake for more than 1 s.
Exit: <QUIT> Is the receiver switched on and ready to receive?
E43 The transmission of the KF Coulometer has been interrupted with
XOFF for at least 6 s.
Exit: Send XON or <QUIT>
E45 The receive buffer of the KF Coulometer contains an incomplete
command (L
F
missing). Sending from the KF Coulometer is
therefore blocked.
Exit: Send L
F
or <QUIT>.
E120 Overrange of the measured value.
Exit: Correct error or &m $S.
E121 Measuring point list overflow (more than 500 measuring points).
Exit: The error message disappears on next start.
E123 Missing EP for calculation.
Exit: The error message disappears on next start or on
recalculation.
E127 Stop time reached.
Exit: The error message disappears on next start.
E128 No new mean.
Exit: The error message disappears on next start or on
recalculation.
E129 No new common variable, old value remains.
Exit: The error message disappears on next start or on
recalculation.
E132 Silo empty and it has been started with open silo or empty silo has
been opened.
Exit: Send a silo entry.
E133 Silo full.
Exit: Send new command.
E134 No method. A method, which is required from the silo memory, does not
exist.
Exit: The error message disappears on next start.
E137 XXX Bytes are missing so that the method, the silo line could not be stored.
Exit: Send new command.
E155 No new silo result (C24 or C25).
Exit: The error message disappears on next start or on recalculation.
E176 The function &Assembly.Buret.Prep or &Assembly.Buret.Empty was
interrupted manually.
Exit: The error message disappears on next start.
E190 Overtitrated. The KF Coulometer is in the Iodine range.
Exit: The error message disappears when the Coulometer is again in the water
range or on next start.
E192 Check generator electrode: Not sufficient solvent in titration vessel or you are
working with fixed generator current or generator electrode defective. The
results of a determination may be erroneous and in the report you will find the
message " work.conditions not ok".
Exit: Rectify error.
E194 Sample unfit. Sample releases oxidative agents during titration.
Exit: Rectify error or &m $S.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Metrohm 756 KF and is the answer not in the manual?

Metrohm 756 KF Specifications

General IconGeneral
BrandMetrohm
Model756 KF
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals