4.2 Remote control commands
756/831 KF Coulometer, Instructions for Use
72
"Setup", continuation
├ .AutoInfo Automatic message for changes 4.2.2.95.
│ ├ .Status Switch AutoInfo on/off ON, OFF ditto
│ ├ .P When mains is switched on ON, OFF ditto
│ ├ .T Titrator infos
│ │ ├ .R When “ready” ON, OFF ditto
│ │ ├ .G When method started ON, OFF ditto
│ │ ├ .GC When start is initiated ON, OFF ditto
│ │ ├ .S When stopped ON, OFF ditto
│ │ ├ .B Begin of method ON, OFF ditto
│ │ ├ .F End of process ON, OFF ditto
│ │ ├ .E Error ON, OFF ditto
│ │ ├ .O Conditioning OK ON, OFF ditto
│ │ ├ .N Conditioning not OK ON, OFF ditto
│ │ ├ .Re Request after start ON, OFF ditto
│ │ ├ .Si Silo empty ON, OFF ditto
│ │ ├ .M Entry in measuring point list ON, OFF ditto
│ │ ├ .EP Entry in EP list ON, OFF ditto
│ │ ├ .RC Recalculation of results done ON, OFF ditto
│ ├ .C Comport infos
│ │ ├ .B1 When COM1 sends a report ON, OFF ditto
│ │ ├ .R1 When COM1 is ready again ON, OFF ditto
│ │ ├ .B2 When COM2 sends a report ON, OFF ditto
│ │ ├ .R2 When COM2 is ready again ON, OFF ditto
│ ├ .PR (only 756) Printer infos
│ │ ├ .B When internal printer is printing ON, OFF ditto
│ │ ├ .R When internal printer is ready again ON, OFF ditto
│ ├ .I Changing an I/O input ON, OFF ditto
│ ├ .O Changing an I/O output ON, OFF ditto
│
├ .Graphics Changing the curve output
│ ├ .COM1 Graphic output on COM1
│ │ ├ .Grid Grid on curve ON, OFF 4.2.2.96.
│ │ ├ .Frame Frame on curve ON, OFF ditto
│ │ ├ .Scale Type of depending axis Full, Auto ditto
│ │ ├ .Recorder Length of axes
│ │ │ ├ .Right Length of meas value axis 0.2...0.5...1.00 ditto
│ │ │ ├ .Feed Length of paper drive axis 0.01...0.05...1.00 ditto
│ ├ .COM2 Graphic output on COM2
│ ├ .Int Graphic output on internal printer
│
├ .PowerOn RESET (power on) $G 4.2.2.97.
├ .Initialise Set default values $G 4.2.2.98.
│ ├ .Select Selection of branch ActMeth,Config,Silo,
│ Assembly,Setup,All ditto
├ .RamInit Initialization of working mem. $G 4.2.2.99.
├ .InstrNo Device Identification $G 4.2.2.100.
├ .Value Input of device identification 8 ASCII characters ditto
To Next Page
Loading...
Need help?
General
