Meyn 0100-5 - Cam Adjustments

Disassembly/assembly and adjustments
© Meyn Food Processing Technology B.V. 39
7.2.2 Adjust the Cams
Five cams (top cam, bottom cam, tail clip cam, back plate cam and knife unit cam) in
which a curve path is milled or grooves are milled drive the processing units.
Figure 7.7 View cams.
• Top cam (A)
• Knife unit cam (B).
• Tail clip cam (C).
• Back plate cam (D).
• Bottom cam (E).
Figure 7.8 View back plate cam.
• Back plate cam (D).
A
B
C
E
D