MGE UPS Systems EX-11RT - Page 9

Installation and User Manual
Figures (continued)
figure description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page
3-1: Initial Startup Display. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 — 1
3-2: Control Panel with scroll up and down buttons. . . . . . . . . . . . . . . . . . . . .3 — 2
3-3: Configuration used to provide cascade redundancy to critical loads . . . .3 — 3
3-4: Normal (double conversion) mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 — 7
3-5: ECO mode display. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 — 8
3-6: Transfer, Threshold and End of backup time . . . . . . . . . . . . . . . . . . . . . .3 — 9
3-7: Shutdown display, circuit breaker, and AC source switch. . . . . . . . . . . .3 — 10
4-1: Disconnecting the Power Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 — 3
4-2: Reconnect the Power Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 — 4
4-3: Rear view of the Battery Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 — 5
5-1: Power supplied as a function of input voltage (left),
and permissible UPS overloads as a function of time (right) . . . . . . . . . .5 — 1
Tables
table description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page
1-1: EX RT Model Descriptions and Contents. . . . . . . . . . . . . . . . . . . . . . . . .1 — 1
1-2: Optional Accessories (See section 1.5 for description) . . . . . . . . . . . . . .1 — 2
1-3: UPS Characteristics System Ratings . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 — 3
1-4: Transformer Module Characteristics Ratings . . . . . . . . . . . . . . . . . . . . . .1 — 3
1-5: Battery Module Ratings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 — 4
1-6: System Dimensions and Weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 — 5
1-7: Battery backup time chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 — 12
3-1: Local Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 — 3
3-2: Output Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 — 3
3-3: ON/OFF Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 — 4
3-4: Battery Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 — 4
3-5: System Operation in I/T and Industrial Modes. . . . . . . . . . . . . . . . . . . . .3 — 5
4-1: Troubleshooting not requiring MGE after-sales support . . . . . . . . . . . . .4 — 1
4-2: Troubleshooting requiring MGE after-sales support . . . . . . . . . . . . . . . .4 — 2
5-1: EX 5/7/11 RT Voltages and Frequency Characteristics . . . . . . . . . . . . . .5 — 1
5-2: Backup Time (in minutes) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 — 2
5-3: Battery Recharge time to recover 90% of the rated backup time
after discharge at full load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 — 3
5-4: Efficiency online (RL load) and batteries fully charged . . . . . . . . . . . . . .5 — 3
5-5: Efficiency online (RCD load) and batteries fully charged . . . . . . . . . . . . .5 — 3
5-6: Efficiency on battery (RCD load). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 — 3
5-7: Efficiency on ECO mode (all kinds of load) and batteries fully charged. .5 — 4
5-8: Full load heat rejection in BTUs/hr . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 — 4
Contents c v86-86000-00 B00