Operating Instructions - Synchroprint 3000 (Manual-Registration Version)
________________________________________________________________________________
Operating Instructions - Synchrprint 3000 (Manual-Registration Version) V1-1 Page 46 of 49
9.3. Permanent Shutdown of the Machine
If the Synchroprint 3000 is to be permanently shut down or decommissioned (e.g. disposed
of/scrapped), upon disassembly all individual parts must be disposed of according to their class and
substance, and in accordance with any respective regulations in effect at that time in the machine’s
particular location/country, and by a suitably reputable and authorised waste-disposal company.
9.4. Stopping the Machine in the event of Malfunction
If the main control system detects any electrical or mechanical malfunction, the main drive will be
disabled/de-activated automatically for the safety and protection of the operating staff.
9.5. Stopping the Machine in the event of an Emergency
If the operator detects any danger to personnel or the Synchroprint 3000, he can immediately shut
down the machine by pressing the EMERGENCY STOP push button.
On both the left and right hand side of the load/un-load stations there are two safety bars marked
yellow/black, which stop the machine immediately when actuated.
Between each print station there are safety barriers marked yellow/black. If any one of these
barriers is opened the machine will stop immediately.
There is an EMERGENCY STOP push button located on the main control
panel. The operating staff must be aware of its location in order to stop the
machine in the event of an emergency as quickly as possible.
These safety devices must not be used to switch off the machine under normal
operation. Any EMERGENCY STOP presents an exceptional loading to the
servo-motor and transmission etc. Excessive use will result in damage to the
machine along with subsequent cancellation of the warranty.
To Next Page
Loading...