69D0023 13
CDV Series Gas Fireplace
INSTALLATION PRECAUTIONS
Consult local building codes before beginning the installation. The installer must make sure to select the proper
vent system for installation. Before installing vent kit, the installer must read this replace manual and vent
kit instructions.
Only a qualied installer/service person should install venting system. The installer must follow these safety
rules:
• Wear gloves and safety glasses for protection.
• Use extreme caution when using ladders or when on rooftops.
• Be aware of electrical wiring locations in walls and ceilings.
The following actions will void the warranty on your venting system:
• Installation of any damaged venting component.
• Unauthorized modication of the venting system.
• Installation of any component part not manufactured or approved by MHS.
• Installation other than permitted by these instructions.
FINISHING MATERIAL
NOTE: Any wiring (i.e. remote control, wall switch, and optional fan) must be done prior to nal nishing
to avoid costly reconstruction.
INSTALLATION INFORMATION
Only noncombustible materials (i.e. brick, tile, slate, steel, or other materials with a UL re rating of Zero) may be used to
cover the black surface of the appliance. A 300°F minimum adhesive may be used to attach facing materials to the black
surface. If joints between the nished wall and the replace surround are sealed, a 300°F minimum sealant material (General
Electric RTV103 or equivalent) must be used.
VENT INSTALLATION
WARNING
WARNING
WARNING
Failure to follow these
instructions will void the
warranty.
To Next Page
Loading...