36 69D0023
Flat
Area
CDV Series Gas Fireplace
FINAL INSTALLATION
LOG PLACEMENT
1. Place rear log (#1) on grate assembly. Log should rest
rmly on the two log mounting pins shown. Figure 51
2. Place top right log (#2) on the rear log. Rest the right
back side of the log in the at area of the rear log. Place
the narrow front end of the log next to the center vertical
grate bar. Figure 51
3. Place the top left log (#3) on the rear log. Nest the
forked end of the top left log into the fork or the rear
log. Rest the narrow end of the top left log behind the
center vertical grate bar. Figure 51
LAVA ROCK AND EMBER PLACEMENT
Sprinkle lava rock on the oor of the inner combustion
chamber. Evenly distribute the rock. Do not pile the lava rock
up in front of grate. Do not place lava rock on the burner.
If desired, purchase optional embers to decorate the oor
of the replace.
Figure 51 - Log Placement
(#3) Top
Left Log
(#2) Top
Right Log
(#1) Rear
Log
Left Vertical
Grate Bar
Right
Vertical
Grate Bar
Center Vertical
Grate Bar
Log Mounting Pins
ROCK WOOL PLACEMENT
1. Place rock wool on burner to provide glowing
embers. For best results, pull the rock wool
apart into pieces the size of a dime or smaller.
NOTE: Embers must be loosely placed to allow
proper burner ame.
2. Distribute one layer of rock wool to cover the
entire burner. Figure 50
3. Place the logs on the burner. See Log Place-
ment below. Light unit and after 15 minutes,
check burner ame and glow. Refer to Burner
Flame, Page 41.
If the ame is blue and only in the center, turn off
unit and let cool. After unit cools, remove logs. If
the back holes are clear, add more rock wool to the
center of the burner. Replace logs and check ame
again. Save left over rock wool to refresh when
cleaning later. Too much rock wool can disturb the
ame and cause sooting on the glass or logs.
Figure 50 - Placement of Rock Wool on Burner
Cover with
Rock Wool
Burner
WARNING
to sooting.
WARNING
To Next Page
Loading...