40 69D0023
Figure 57 - Electronic Gas Valve
CDV Series Gas Fireplace
ELECTRONIC IGNITION OPERATING INSTRUCTIONS
LIGHTING ELECTRONIC IGNITION
A. This appliance is equipped with an ignition
device (Piezo) which automatically lights
the pilot. Do NOT try to light the burner by
hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next
to the oor because some gas is heavier than
air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS:
• Turn off all gas to the appliance.
• Open windows.
• Do not attempt to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instruc-
tions.
• If you cannot reach your gas supplier, call the re department.
C. Turn off all electric power to appliance.
D. Do not use this appliance if any part of it has been under water. Immediately call a qualied ser-
vice technician to inspect the appliance and to replace any part of the control system and any
gas control that has been under water.
FOR YOUR SAFETY READ BEFORE LIGHTING
TO TURN OFF GAS
1. Open lower door.
2. Turn RS-OFF_ON rocker switch to “OFF”.
3. Turn off all electric power to the appliance if service is to be performed.
4. Close lower door.
DANGER
Never use an open
WARNING
If you do not follow these instructions
1. STOP! Read the safety information above.
2. Set switch to off.
3. Turn off electric power to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the burner. Do not try to
light the burner by hand.
5. Wait 5 minutes to clear out any gas. Then smell for
gas, including near the oor. If you smell gas STOP!
Follow “B” — What to Do if You Smell Gas above. If you do not smell gas, go to the next
step.
6. Turn on all electric power to appliance.
7. Turn RS-OFF-ON rocker switch to “ON”.
8. If the appliance will not operate, follow the instruction To Turn Off Gas below and call your service
technician or gas supplier.