4 69D0023
CDV Series Gas Fireplace
IMPORTANT SAFETY INFORMATION
Continued from page 3
10. Have venting system inspected annually by a quali-
ed service person. If needed, have venting system
cleaned or repaired. See Cleaning and Maintenance,
page 40.
11. Keep the area around your replace clear of combus-
tible materials, gasoline, and other ammable vapor
and liquids. Do not run replace where these are
used or stored. Do not place items such as clothing
or decorations on or around replace.
12. Do not use this replace to cook food or burn paper
or other objects.
13. Never place anything on top of replace.
14. Do not use any solid fuels (wood, coal, paper,
cardboard, etc.) in this replace. Use only the gas
type indicated on rating plate.
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.
16. Do not obstruct the ow of combustion and ventila-
tion air in any way. Provide adequate clearances
around air openings into the combustion chamber
along with adequate accessibility clearance for
servicing and proper operation.
17. When the appliance is installed directly on carpet-
ing, tile or other combustible material other than
wood ooring, you must set appliance on a metal
or wood panel or hearth pad extending the full width
and depth of the appliance.
18. Do not use replace if any part has been exposed to
or has been under water. Immediately call a quali-
ed service person to arrange for replacement of
the unit.
19. Do not operate replace if any log is broken.
20. Do not use a blower insert, heat exchanger insert,
or any other accessory not approved for use with
this replace.
21. Do not operate the fireplace with glass door
removed, cracked, or broken.
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
It is normal for replaces fabricated of steel to
give off some expansion and/or contraction noises
during the start up or cool down cycle. Similar
noises are found with your furnace heat exchanger
or car engine.
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
It is not unusual for gas replace to give off some
odor the rst time it is burned. This is due to the
manufacturing process.
It is recommended that you burn your replace for
at least ten (10) hours the rst time you use it. Place
the fan switch in the “OFF” position during this time.
WARNING
Never connect unit to private
To Next Page
Loading...