To Next PageTo Next Page
Need help?Do you have a question about the Microhard Systems pX2 and is the answer not in the manual?
General| Brand | Microhard Systems |
|---|---|
| Model | pX2 |
| Category | Wireless Router |
| Language | English |
Details Microhard's product warranty, disclaimers, and limitations for use.
Covers purchaser indemnification and Microhard's intellectual property rights.
Assumes user familiarity with system integration and radio communication fundamentals.
Explains FCC and Industry Canada RF exposure, operation, and labeling guidelines.
Key features include high power Tx, 150 Mbps data rate, 802.11b/g/n, firewall, and dual Ethernet.
Details electrical, environmental, and mechanical specifications for the pX2 module.
Table detailing rate, mode, Tx Power, and Receive specifications for various Wi-Fi standards.
Steps for connecting antenna, power, PC, and configuring network settings for basic setup.
Procedure to configure two pX2 modules as an Access Point and a Station/Client.
Describes the pX2 modem as an OEM module for integration and evaluation.
Provides dimensional drawings and specifications for the pX2 OEM Module.
Lists pin names, numbers, descriptions, and direction for the pX2 80-pin connector.
Details the pX2 development board for testing, listing its interfaces and indicators.
Identifies connectors and indicators on the pX2 development board.
Outlines initial configuration steps using the WebUI, including IP setup and login.
Configures system parameters like hostname, logging, services, and maintenance.
Manages network interfaces: status, LAN, WAN, ports, and device list.
Sets up wireless parameters including status, radio settings, and virtual interfaces.
Manages firewall rules, general settings, port forwarding, and MAC/IP lists.
Configures the RS232 serial port, including status, baud rate, and IP protocol.
Configures application-level features like event reporting and diagnostics.
Provides tools for network testing: Ping, Traceroute, and Iperf.
Manages users, authentication, NMS, SNMP, discovery, and logout.
Introduces AT Commands for configuring and managing the pX2 via telnet.
Details the syntax for issuing AT Commands, including query and set value formats.
Lists and describes various AT Commands for device configuration and control.
Discusses factors for deploying radio networks: topology, throughput, distance, terrain, power, sensitivity.
Provides formula for determining adequate radio signal path and fade margin.
Covers installation of antenna system components, requiring qualified personnel.
Details the signals and connections for the RS-232 serial interface.
Step-by-step guide for recovering firmware on an unresponsive unit.
Lists approved antenna types and their maximum permissible gain for FCC/Industry Canada.
Provides a sample schematic for interfacing with the pX2 OEM module.
Addresses common support questions and provides solutions for pX2 problems.
