© Microhard Systems Inc. 35
4.0 Configuration
System Log Server IP
The pX2 can report system level events to a third party System Log server,
which can be used to monitor events reported by the PX2.
IP Address
0.0.0.0
System Log Server Port
Enter the UDP listening port of the System Log Server. The default port
number is generally 514, but could vary from Server to Server.
UDP Port
514
Time Settings
The pX2 can be set to use a local time source, thus keeping time on its own, or it can be configured to
synchronize the date and time via a NTP Server. The options and menus available will change depending
on the current setting of the Date and Time Setting Mode, as seen below.
Image 4-1-3: System Settings > Time Settings
Network Time Protocol (NTP)
can be used to synchronize the
time and date or computer
systems with a centralized,
referenced server. This can
help ensure all systems on a
network have the same time
and date.
Date and Time Setting Mode
Select the Date and Time Setting Mode required. If set for ‘Local Time’
the unit will keep its own time and not attempt to synchronize with a
network server. If ‘NTP’ is selected, a NTP server can be defined.
Values (selection)
Local Time
NTP
CFG Reset to Default Button
Enabled by default, when the CFG button on the front of the pX2 is held
down for 10s while the unit is powered up, the unit will reset and all settings
will be reset to factory defaults. When disabled the unit will reset, but the
settings will not be overwritten.
Values (Selection)
Enable
Disable
To Next Page
Loading...