© Microhard Systems Inc. 86
4.0 Configuration
Default Settings
The default Settings link will reset the configuration form to the default factory values. The form still needs
to be submitted before any changes will occur.
NMS Server/IP
The default server address for NMS is nms.microhardcorp.com.
Values (IP/Name)
nms.microhardcorp.com
Domain Name / Password
This is the domain name and password that was registered on the NMS
website, it must be entered to enable reporting to the NMS system.
Values (chars)
default
Carrier Location
Enable or Disable location estimation via carrier connection. When
enabled, the pX2 will consume some data to retrieve location information
from the internet.
Values (chars)
Disable/Enable
Remote Port
This is the port to which the UDP packets are sent, and the NMS system is
listening on. Ensure this matches what is configured on NMS. The default
is 20200.
Values (UDP Port#)
20200
Network Management System (NMS) Configuration
NMS Report Setting
Report Status
Enable or Disable UDP reporting of data to the NMS system.
Values (chars)
Enable NMS Report
Disable NMS Report
Interval(s)
The Interval defines how often data is reported to NMS. The more often
data is reported, the more data is used, so this should be set according to a
user’s data plan. (0 to 65535 seconds)
Values (seconds)
300
To Next Page
Loading...