Microhard Systems pX2 - Page 87

© Microhard Systems Inc. 87
4.0 Configuration
Information Selection
The pX2 can report information about the different interfaces it has. The
more that is reported, the more data that is sent to the NMS system, be
aware of data plan constraints and related costs.
Values (check boxes)
Ethernet
Radio
COM
Status
The Web Service can be enabled or disabled. This service is used to
remotely control the pX2. It can be used to schedule reboots, firmware
upgrade and backup tasks, etc.
Values (chars)
Disable/Enable
Server Port
This is the port where the service is installed and listening. This port should
be open on any installed firewalls.
Values (Port#)
9998
Webclient Setting
Server Type
Select between HTTPS (secure), or HTTP server type.
Values (chars)
HTTPS/ HTTP
Username / Password
This is the username and password used to authenticate the unit.
Values (seconds)
admin/admin
Interval
The Interval defines how often the pX2 checks with the NMS System to
determine if there are any tasks to be completed. Data will be consumed
every time the device probes the NMS system.
Values (min)
60