What can I
do?
Press the “RESET” button for 7 seconds to restore the Router to default
settings.
3. The computer connected with the Router shows IP address
conflict. What can
do?
Check if there are other DHCP servers in the LAN and if there are then
disable them. The default IP address of the router is 192.168.1.1 please
maker sure the address is not being used by any other device. If there are
two computers with the same IP address, please change one of them.
4. I cannot use E-mail and access the Internet. What can I do?
Sometimes happens with ADSL connection and Dynamic IP users. You
may need to modify the default MTU value (1492). Please open the “WAN
Setting” and modify the MTU value with the recommended value as 1450
or 1400.
5.How to share my computer’s resource with other users in Internet：
If you want Internet users to access the internal server via the router such
as: e-mail server, Web, FTP. You can configure the “Virtual Server”.
Step 1: create your internal server, make sure the LAN users can access
these servers and know related service port. For example, Web server’s
port is 80; FTP is 21; SMTP is 25 and POP3 is 110.
Step 2: In the router’s web click “Virtual Server” and select “Port Range
Forwarding”.
Step 3: Input the service port provided by the router (i.e. the external port)
for mapping the internal and external network, for example, 80-80.
Step 4: input the internal Web service port, for example, 80-80.
Step 5: Input the internal server’s IP address. For example, if your Web
server’s IP address is 192.168.1.10, please input it.
Step 6: select the communication protocol used by your internal host: TCP,
UDP, Both.
Step 7: click “Ok” to activate the settings.
The following table lists some well-known applications and their respective
To Next Page
Loading...
