46
Data Port or Power Supply Jack areas.
5.3. Do not let liquid accumulate near any opening, make sure no
liquid enters the meter.
5.4. Leave meter “wet” for 2 minutes or the recommended time.
5.5. With a fresh dry cloth (like a Kimwipe
®
) remove any residual
moisture.
5.6. Once the meter is dried with the Kimwipe it is ready for use.
11.1.6 Visually verify that no residual moisture is on the meter or sample area.
11.2 Precautions for Lithium-ion Battery
When the instrument is turned on for the rst time, the battery must be
fully charged.
Fully charge the meter prior to storage or extended non-usage.
For storage greater than three months, recommend recharge every three
months to avoid battery capacity discharge and decay.
11.3 Servicing
No user serviceable components. All service and adjustment must
be performed by Micropoint Biotechnologies Co., Ltd
To Next Page
Loading...