Microsemi SmartFusion2 - 4 Appendix: Error Codes; Table 4 Error Codes

Appendix: Error Codes
DG0584 Demo Guide Revision 5.0 24
4 Appendix: Error Codes
The following table lists the information about the error codes.
Table 4 • Error Codes
Define Error Code Description
#define MSS_SYS_CHAINING_MISMATCH 1 Device contents mismatch
#define MSS_SYS_UNEXPECTED_DATA_RECEIVED 2 Data is not supported
#define MSS_SYS_INVALID_ENCRYPTION_KEY 3 Invalid encryption key
#define MSS_SYS_INVALID_COMPONENT_HEADER 4 Invalid file
#define MSS_SYS_BACK_LEVEL_NOT_SATISFIED 5 Corrupted/ Invalid file
#define MSS_SYS_DSN_BINDING_MISMATCH 7 Corrupted/ Invalid file
#define MSS_SYS_ILLEGAL_COMPONENT_SEQUENCE 8 Corrupted/ Invalid file
#define MSS_SYS_INSUFFICIENT_DEV_CAPABILITIES 9 Invalid Device capabilities
#define MSS_SYS_INCORRECT_DEVICE_ID 10 Invalid Device ID
#define MSS_SYS_UNSUPPORTED_BITSTREAM_PROT_VER 11 Bitstream not supported
#define MSS_SYS_VERIFY_NOT_PERMITTED_ON_BITSTR 12 Verification not allowed for input
bitstream
#define MSS_SYS_ABORT 127 Operation aborted
#define MSS_SYS_NVM_VERIFY_FAILED 129 eNVM verification failed
#define MSS_SYS_DEVICE_SECURITY_PROTECTED 130 Device secured
#define MSS_SYS_PROGRAMMING_MODE_NOT_ENABLED 131 Programming mode not enabled