© 2014 Microsoft Page 7
Set up your Surface
Grab your Surface and let’s go!
Before you start… Make sure a wireless network is available and you have the network password (if the network
is secured).
Plug in and turn on
1. If you have a Typing Cover, bring it close to your Surface, so that it clicks into place (see picture).
2. Flip out the built-in kickstand on the back of Surface (either position).
3. Plug the power cord into a wall outlet or power strip.
4. Connect the power connector to the charging port on Surface (either direction works).
The ring of light near the end of the connector means Surface is getting power.
5. Press and release the Power button (on the top right edge).
Surface turns on and setup begins.
To Next Page
Loading...
