• 42 •
Retesting jar posts or straps
Factors such as operating and site conditions, and manufacturer changes, can affect test results.
If you accept results under these conditions, your maintenance routine might not have an accurate
history. To verify results, you can retest a set of jar posts or straps right after you test them. Or you
can test the rest of the string before you retest certain jar posts or straps.
Retesting after immediately testing the jar post or strap
To retest a set of jar posts or a strap just after you test it, press RETEST. The analyzer displays new
test results.
Retesting after testing the string
To retest a set of jar posts or a strap after you test the entire string:
1. Remove the clamps/probes from the set of jar posts or the strap.
2. Press and hold the
POWER button to turn on the analyzer.
3.
Press the ARROW keys to highlight the REPORTS icon in the Main Menu, and press ENTER
.
4. Press the
ARROW keys to highlight the JAR DATA icon, and press ENTER.
5. Press the
ARROW keys to scroll to the string fi le that has the jar or strap you want to retest,
and press
ENTER.
6. Press the
ARROW keys to scroll to the jar or strap you want to retest.
7. Press the
RETEST key.
8. After retesting, the analyzer will display the new results. To retest another jar or strap, scroll
to it and press the
RETEST key.
9. Press the
BACK key to end.
Adding a placeholder for a missing or dead jar/battery
You can create a placeholder for a dead or missing battery by using the ADD BATTERY
option in the REPORTS MENU. There are two ways to add a placeholder.
NOTE: If you have selected JARS & 1 STRAP or JARS & 2 STRAPS as the test mode, you
must also add a placeholder for the strap.
When testing a string
1. When the analyzer displays the last good test results, disconnect from the jar and press the
BACK key to return to the Main Menu. Select the TEST icon, and press ENTER.
2. The analyzer will display the following screen:
Chapter 6: Testing Celltron ULTRA
To Next Page
Loading...
Need help?
General
