Miele cva 610 - Dispenser Assembly Removal

Technical Information
48
CVA 610/CVA 615 Coffee Systems
Figure 5-16: Selection/Display Electronic Removal
1
Pushbuttons
2
Display electronic
3
Display electronic screws
4
Selection-display electronic interface
5
Control and power electronics connection
6
Selection electronic screws
7
Selection electronic
5.20 Dispenser Assembly Removal
1. Open the door.
2. Remove the grille and drip tray from the door.
3. Remove the screws securing the white panel (on the left and right of the cover).
4. Remove the white panel.
Note:
The two screws securing the dispenser assembly are on the rear of the assembly.
5. Remove the 2 screws securing the dispenser assembly to the inside of the door.
6. Pull out the hose (Figure 5-17, Item 6) from the outlet (Figure 5-17, Item 7).
7. Pull out the dispenser assembly (Figure 5-17, Item 9) partway.
8. Unclip and remove the outlet.
9. Remove the dispenser assembly from the appliance.