Technical Information
66
CVA 610/CVA 615 Coffee Systems
Figure 5-39: Upper Front Plate Assembly Retaining Screws
25. Move the drive assembly cover toward the rear wall of the appliance.
26. Move the drive assembly back while lifting upward to remove it from the
appliance. Use caution; the wiring harness is short.
Service Tip:
Refer to Figure 5-40. To avoid having to hold the front plate assembly
upward while removing the lower screws, a suitable item can be used to
temporarily keep the front plate assembly in an elevated position.
Figure 5-40: Elevating Front Plate Assembly to Access Bottom Screws
27. Position the drive assembly so that access to the rear cover is possible.
28. Remove the 5 screws that secure the cover.
29. Lift the cover from the drive assembly.
30. Refer to Section 4.15 for information on the drive assembly.
To Next Page
Loading...
