Roasting
106
You can also delay the start of the
cooking programme to a later time. To
do this, select Change| Open further
settings and enter a time in the Start at
field. In Automatic Programmes, select
Start later.
You can estimate approximately when
the food will be ready as the duration of
the cooking programme is about the
same as if you were cooking food
without using the food probe.
Duration and Finish at cannot be set, as
the total cooking duration is
determined by how long it takes for
the core temperature to be reached.
Displaying the core temperature
The core temperature appears in the
display after the heating-up phase with
conventional functions.
With MChef functions the Gourmet
Units appear after the heating-up
phase. The core temperature can also
be displayed.
Select Stop to stop the addition of
Gourmet Units early.
The actual core temperature will appear
in the display.
Select Start to continue the addition
of Gourmet Units.
The Gourmet Units will be added to the
food and the number of units will
appear in the display.
Using residual heat
The oven heating turns off shortly
before the end of the cooking
programme. The remaining heat in the
oven is enough to finish the cooking
programme.
Using the residual heat in the oven
saves energy.
Energy save phase will appear in the
display to show that the oven is in
energy save mode. The measured core
temperature is no longer visible.
The cooling fan continues to run, as
does the hot air fan if a function using
the fan has been selected.
Once the core temperature has been
reached, Process finished will appear in
the display and a buzzer will sound if
buzzer tones are switched on.
Useful tip: If the food is not yet cooked
sufficiently, insert the food probe into
another place and repeat the
programme.
To Next Page
Loading...
