Functions using moisture
91
Injecting bursts of steam
Steam can cause scalding.
Do not open the door during a burst
of steam. Also, condensation on the
sensors will cause them to have a
slow reaction time.
Automatic burst of steam
Automatic burst of steam appears in the
display.
Once the heating-up phase has been
completed, the steam is released
automatically.
The water will vaporise in the oven
whilst steam is being released and Burst
of steam active will appear in the display.
After the burst of steam, Burst of steam
finished will appear in the display.
Continue cooking until the end of the
programme.
1, 2 or 3 bursts of steam
Manual bursts of steam
If you have selected Manual, you can
release the bursts of steam as soon as
Start Manual burst of steam appears in the
display.
Please wait until the heating-up phase
is completed to allow the steam to be
distributed evenly by the warm air in
the oven.
Useful tip: Please refer to the recipes in
the Dialog oven cookbook for the timing
of the bursts of steam. Set the minute
minder to remind you when to do so.
Select Start Manual burst of steam.
The burst of steam is released and Burst
of steam active appears in the display.
Proceed as described to inject further
bursts of steam.
At the end of each burst of steam Burst
of steam finished appears in the display.
Continue cooking until the end of the
programme.
Time-controlled bursts of steam
The Dialog oven will then release the
steam at the specified times.
To Next Page
Loading...
