Miele PWM 908 User Manual

Installation
72
Installation locations
Side view
1132
850
1100
714
Washer-dryer stack
min. 300
1702
The washing machine can be installed
as a washer-dryer stack together with a
Miele tumble dryer. A WTV stacking kit
(optional accessory) is required for this.
Installation on a plinth
The washing machine can be installed
on a steel plinth (open or closed, avail-
able as an optional Miele accessory) or
on a concrete plinth.
 Injury can occur if the washing
machine has not been adequately
secured.
When installing the machine on a
plinth, there is the danger of the
washing machine falling off the plinth
during spinning.
Secure the washing machine using
the clamps supplied.
Installation notes
This washing machine is not suitable
for building under.
 Risk of damage due to moisture
ingress.
Moisture can damage electrical com-
ponents.
Do not install the machine near or
directly above an open gully or floor
drain.
The washing machine must not be
connected to devices such as timers
which would switch it off automatic-
ally.

Miele PWM 908 Specifications

General

Door hinge	Right
Water fill	Cold, Hot
Drum volume	73 L
Control type	Touch
Loading type	Front-load
Certification	CE, VDE-EMV, VDE, WEEE, IPX4
Product color	Silver
Built-in display	Yes
Custom panel-ready	-
Door opening angle	167 °
Appliance placement	Freestanding
Package depth	768 mm
Package width	660 mm
Package height	940 mm
Package weight	107000 g
Current	10 A
Connected load	5500 W
AC input voltage	400 V
AC input frequency	50 Hz
Water consumption per cycle	- L
Energy consumption washing per cycle	- kWh
Drum capacity	8 kg
Delay start (max)	96 h
Spin-drying class	A
Maximum spin speed	- RPM
Noise level (spin)	70 dB
Noise level (wash)	46 dB

Weight and Dimensions

Depth	714 mm
Width	605 mm
Height	850 mm
Weight	103000 g