Supervisor level
94
If the auto load control is deactivated,
the machine will always carry out the
programme sequence based on a full
load.
Factory setting: On
Controlled energy cons.
With this option selected, the machine
will optimise the energy it uses in the
Whites, Coloured items and Minimum
iron programmes.
Factory setting: On
Service
Clean drain pump
The user sees a message when the
drain pump filter has to be cleaned.
The message is displayed every 500
operating hours.
The message appears at the end of the
programme.
Factory default: Off
Service interval
Service information can appear in the
display. You can configure whether a
date or the number of operating hours
is displayed.
You can select up to 3 messages with
their own text.
Your message is displayed at the end of
the programme and can be acknow-
ledged with OK. The same message
appears at the end of the next pro-
gramme.
Settings
This setting allows you to determine the
interval (depending on hours or date) at
which the message appears.
– Factory default: Off
– By time
You can then select a time interval
from 1–9999 hours.
– By date
You can then enter a date.
Message text
Enter your message for your planned
maintenance work.
Reset display
The message appears until the display
is permanently reset. The message then
appears again once the next interval is
reached.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
