Supervisor level
98
SmartGrid
The SmartGrid setting is only visible if a
WiFi network has been set up and ac-
tivated. This function can be used for
starting your washing machine auto-
matically at a time when your energy
supplier's energy costs are most eco-
nomical.
Activating SmartGrid gives the Timer
sensor control a new function. Use the
“Timer” sensor control to configure
SmartStart. The washing machine will
then start within the timeframe specified
by you when it receives a signal from
your energy supplier. If a signal has not
been received from the energy supplier
by the latest start time set, the washing
machine will start automatically.
Factory default: Off
Machine parameters
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a pro-
gramme with a temperature of 70°C or
higher is selected.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes do not
comply with DIN 1986.
Factory setting: On
Water inlet
Pre-wash
You can select the water type for the
pre-wash.
– Cold
Only cold water is used for the pre-
wash.
– Hot
Hot water is also added for the pre-
wash.
Hot water can only be added if the
wash temperature is above 30°C.
To Next Page
Loading...
