Miele PWM 908 - Low Water Pressure; Automatic Dispensing; Capdosing

Supervisor level
99
Main wash
You can select the water type for the
main wash.
– Cold
Only cold water is used for the main
wash.
– Hot
Hot water is also added for the main
wash.
Hot water can only be added if the
wash temperature is above 30°C.
Programme durations will be longer if
the machine is not connected for hot
water; this may mean that the “Time
left” display is incorrect.
First rinse
You can select the water type for the
first rinse in some programmes.
– Cold (factory default)
Only cold water is used for the first
rinse.
– Hot
Hot water is also added for the first
rinse.
Final rinse
You can select the water type for the
last rinse in some programmes.
– Cold (factory default)
Only cold water is used for the final
rinse.
– Hot
Hot water is also added for the final
rinse (only possible for programmes
with a temperature of at least 60°C).
Low water pressure
If the water pressure is below 100kPa
(1bar), the programme will be can-
celled and the fault message Check
water inlet will appear.
If the on-site water pressure cannot be
increased, activating the setting Low wa-
ter pressure will prevent the programme
from being cancelled.
Factory default: no
Automatic dispensing
Automatic dispensing via an external
dispensing system can be activated
Factory default: Off
CapDosing
You can choose whether CapDosing is
displayed in the programme settings.
Factory setting: On