Supervisor level
87
Clock display
After selecting the clock format, you
can set the time of day.
Clock format
– 24h clock (factory default)
– 12h clock
– No clock
Set
– The time of day can be set.
Date
The date can be set after selecting the
date format.
Date format
– DD.MM.YYYY (factory default)
– YYYY.MM.DD
– MM.DD.YYYY
Date
– The date can be set.
Volume
The volume for various sounds can be
changed.
– Finish tone
– Keypad tone
– Welcome tone
It can be set to one of 7 different
levels or switched off altogether.
– Fault alarm
The fault alarm can be activated or
deactivated.
Visibility parameters
Various parameters, such as the tem-
perature, spin speed, Extras, etc., are
displayed when a programme is selec-
ted. You can decide which parameters
should not be displayed. These para-
meters can then not be edited during
programme selection.
Factory default: all parameters are vis-
ible (marked in orange)
Sort Extras
Under the setting Visibility parameters,
Sort Extras appears in the bottom line.
Touch the sensor control to change
the sequence of Extras (see “Arranging
programmes” under “Supervisor
level”).
To Next Page
Loading...
