OM-272384 Page 10
SECTION 3 – SPECIFICATIONS
3-1. Serial Number And Rating Label Location
The serial number and rating information for this product is located on back. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.
3-2. Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula and are incorporated by reference herein.
3-3. Information About Default Weld Parameters And Settings
NOTICE – Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical
welding parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are
for reference purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriate-
ness of all parameters and settings should be evaluated and modified by the end user as necessary based upon application-specific require-
ments. The end user is solely responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld
parameters and settings, and ultimate quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warran-
ties including any implied warranty of fitness for a particular purpose.
3-4. Specifications
Wire Diameter
Range
Wire Feed Speed
Range
Cooling Method
Maximum Spool
Size
Weld Circuit
Rating
Overall
Dimensions
Weight
.030 thru .035 in.
(0.8 thru 0.9 mm)
4000 & 5000 Ser-
ies Aluminum,
Steel, Stainless
Steel
115 to 715 ipm*
(2.92 to 18.16
mpm)*
Air Cooled
4 in. (102 mm)
Diameter
22.5 Volts, 150
Amperes, 60%
Duty Cycle
Length: 12.5 in.
(318 mm)
Width: 3.0 in. (76
mm)
Height: 11.5 in.
(291 mm)
7.33 lb
(3.32 kg)
Gun with Cable
Assembly
*Actual wire feed speed range will vary depending on welding power source.
To Next Page
Loading...
