OM-272384 Page 21
SECTION 6 – MAINTENANCE AND TROUBLESHOOTING
6-1. Routine Maintenance
Disconnect power before maintaining.
F
Maintain more often during severe conditions.
ü = Check ◇ = Change m = Clean ¶ = Replace
Every 3
Months
A complete Parts List is available at www.MillerWelds.com
SECTION 6 MAINTENANCE AND TROUBLESHOOTING
Every
3
Months
Weld Terminals
Labels
Every
3
Months
6-1. Blowing Out Inside of Unit
804746-B
¶ Unreadable Labels m Weld Terminals ¶ Damaged Gas Hose ü ¶ Weld Cables
ü ¶ Cords ü ¶ Gun Cables
Every 6
Months
Complete Parts List is available at www.MillerWelds.com
OM-278215 Page 33
1/2 in.
(13 mm)
SLUDGE
FUEL
m Drive Rolls m Inside Unit
*To be done by factory authorized service agent.
To Next Page
Loading...
