4-5
Troubles for which error messages are given on the LCD
4
In Case of Trouble
Error message Cause Remedy
ERR34 DAT REMAIN
The plotter executed an improper
operation during a halt.
Press the key to cut the
remaining data or execute data clear if
there is no need of using the data in
the receiver buffer.(
P.3-52)
ERR36 MARKdetect
(Show this message
itself)
No registration mark was detected.
(Right after the sheet detection)
Check the sheet for curling.
Check to see if the starting point to
detect the registration mark has been
set properly. (
P.3-24)
Check to see if the black registration
mark is printed against the white
background.
Check to see if there is no dust or dirt
between the registration marks.
Check to see if there is no mistake in
registration mark settings. (
P.3-18)
Confirm the status and the settings
described above. If still no registration
mark is detected, contact your
distributor or a sales office of MIMAKI.
ERR37 MARK ORG
The origin point was detected outside
the cutting area.
Arrange the registration marks inside
the sheet.
ERR38 MARK SCALE
Registration mark detection was not
achieved. However, this error is
attributable to a false detection or a
compensation value setting error,
since the calculated compensation
value is wrong.
Correct the compensation value if it is
wrong, and perform detection again.
The required scale compensation
value was not smaller than 1.3 times
or not greater than 0.7 times.
Remove the cause of the detection
error, for example, correct the blurred
print of registration mark data and then
retry.
A detection error occurred since the
distance from the adjacent graphics
was too short.
Increase the distance from the
adjacent graphics properly, and
perform printing again.
The designateed spacing between
the registration marks is not correct.
The value of the spacing between the
registration marks designated by the
command is wrong and it is attributable
to a selection error of data. Therefore,
check the output data.
The print is not uniform and some
graphics are omitted.
Correct the graphic data to obtain
uniform print and perform printing
again.
As the printed registration mark was
blurred, it was not read correctly and
the registration mark of the next
graphics was read by mistake.
Perform printing again with care that
the print is not blurred.
REMOTE
To Next Page
Loading...
