4-6
Error message Cause Remedy
ERR36 MARKdetect
and
“JOG & ENT or END”
are displayed
alternately.
“ERR38
MARKSCALE”
and
“JOG & ENT or END”
are displayed
alternately.
No registration mark was detected.
(During copy-cutting operation)
( P.3-21)
When using elastic sheet or sheet
whose width is more than
approximately 800mm, use 3 pieces of
pinch rollers.
Check to see if there is no print or dirt
between the registration marks.
Check to see if the black registration
mark is printed against the white
background.
Check to see if there is no mistake in
registration mark settings. (
P.3-18)
When using a non elastic sheet, the
registration mark to be used should be
8 mm or more on a side. Separate the
copied registration marks from each
other by 8 mm or more.
In case error occurs, the Light Pointer
stops at the detection starting point. If
the position is found improper, move
the Light Pointer to the appropriate
position using jog keys.
Press the key to make the
plotter perform detection again.
In case no registration mark is
detected even by retrying the detection
several times, contact your distributor
or a sales officeof MIMAKI.
ERR40 MOTOR A
An excessive load was applied to the
sheet feeding motor.
Turn the power off once and turn it on
again.
Change the sheet setting to [HEAVY].
(
P.3-70)
When a roll sheet is used, perform
sheet feeding to draw it out by a
needed length beforehand.
If the same error message still
appears, contact your distributor or a
sales office of MIMAKI.
ERR41 MOTOR B
An excessive load was applied to the
carriage driving motor.
ERR42 A CURRENT
An overcurrent error in the motor in
the sheet feeding direction was
detected.
ERR43 B CURRENT
An overcurrent error in the motor in
the sheet width direction was
detected.
ERR50 ORIGIN
The plotter has failed to detect the
sheet size.
Turn the power off once and turn it on
again.
If the same error message still
appears, contact your distributor or a
sales office of MIMAKI.
To Next Page
Loading...
