MIMAKI CG-100SRII - Page 85

3-37
Cut Out Data with Registration Mark
3
Useful Function
Alignment of MARK SENSOR
The offset value of the cutter and the mark sensor can be adjusted.
Set the sheet on which the register mark is printed.
Usable on Firmware Ver.1.1 or lator.
1
Install a cutter in the tool holder.
2
Confirm that the plotter is in the local
mode.
3
Press the key.
4
Select [MARK SENSOR] by pressing
the jog key or .
5
Press the key.
6
Select [SENSOR OFS] by pressing the
jog key or .
CUT1 20 050 0 . 30
DATA CLEAR <ENT >
FUNCTION
MARK s e n s o r < ENT >
SENSOR CHK <en t >
ENTER/HOLD
SENSOR OFS <e n t >