MIMAKI CG-100SRII - Page 86

Cut Out Data with Registration Mark
3-38
7
Press the key.
• The offset value of the cutter and the mark sensor
can be adjusted.
• Set the sheet on which the register mark is printed.
8
Enter the corrected value (mm) by
pressing the for the A
direction, or the for the B
direction.
• If misaligned by +0.2 mm, enter "-0.2".
9
Press the key.
• The plotter will return to the local mode after
registering the compensation value.
• The setting values are kept in memory even when the power is turned off.
• The sensor offset value selected by this operation is not initialized by SETUP RESET
operation.
A=0 . 0 B=0 . 0
ENTER/HOLD
A direction
B direction
Misaligned by +0.2 mm from
the center line of the register
mark ( ) in the A and the
B direction.
A= - 0 . 2 B= - 0 . 2
CUT1 20 050 0 . 30
ENTER/HOLD