3-52
Set the configurations with a computer
Set the configurations with a computer
Set the communication condition with the RS-232C interface.Settings of the communication conditions differ
with the command (AUTO, MGL-I c1 or MGL-II c) specified using the command change-over function.
1
Press the key in the local mode.
2
Press the jog key or to select [SET UP] .
3
Press the key.
4
Press the jog key or to select
[INTERFACE] .
5
Press the key.
6
Press the jog key or to select [BAUD
RATE].
• Set values: 1200, 2400, 4800, 9600, 19200, 38400(bps)
7
Press the key.
8
Press the jog key or to select the following items.
• The following items are provided for the setting of registration mark detection:
Data bits, Parity / Stop bits / Handshake / Step size / Close time
• See pages P.3-53 for the contents of each setting item.
9
Press the key.
10
Press the jog key or to select the set values.
• See pages P.3-53 for the contents of each setting item.
• If you have changed the step size, be sure to raise the pinch rollers using the sheet set lever and re-
load the sheet on the device.
• The recommended setting value is “38400(bps)”.
• Set the transfer speed of the host computer to CG-SRIII.
FUNCTION
To Next Page
Loading...
