4-6
Error message Cause Remedy
ERROR 401
MOTOR X
An excessive load was applied to the
sheet feeding motor.
Turn the power off once and turn it on
again.
Change the sheet setting to [HEAVY].
(
P.3-78)
When a roll sheet is used, perform sheet
feeding to draw it out by a needed length
beforehand.
If the same error message still appears,
contact your distributor or a sales office of
MIMAKI.
ERROR 402
MOTOR Y
An excessive load was applied to the
carriage driving motor.
ERROR 403
X CURRENT
An overcurrent error in the motor in the
sheet feeding direction was detected.
ERROR 404
Y CURRENT
An overcurrent error in the motor in the
sheet width direction was detected.
ERROR 50a
Y ORIGIN
The plotter has failed to detect the origin
sensor.
Turn the power off once and turn it on
again.
If the same error message still appears,
contact your distributor or a sales office of
MIMAKI.
ERROR 50b
FRONT EDGE
The plotter has failed to detect the front
paper sensor.
ERROR 50c
WIDTH
The plotter has failed to detect the pinch
roller sensor.
ERROR 520
REAR EDGE
The plotter has failed to detect the rear
paper sensor.
ERROR C51
PINCH POS∗
Pinch rollers are not properly set on the
grit roller.
Set the pinch rollers on the grit roller.
ERROR C60
PenEncoder
The height of the pen cannot be detected.
Turn the power off once and turn it on
again.
If the same error message still appears,
contact your distributor or a sales office of
MIMAKI.
ERROR C61
Pen Stroke
The height of the pen is not proper.
Check whether the pen line rubber is not
extremely worn or there is neither lifting nor
change of shape.
Check whether a foreign material adheres
on the pen line rubber.
When attaching a pen in a pen holder in the
marketplace, check whether it is attached
in the proper position.
Even if there is no abnormality in the above
mentioned items and an error is still
displayed, contact our sales office.
To Next Page
Loading...
