iii
Other Useful Functions ......................................... 3-47
Feed the paper ........................................................3-47
HOLD ......................................................................3-48
DATA CLEAR - Discontinue Plotting - ..................3-48
Perform SAMPLE CUT to Find out the Cause of Cutting
Error. .......................................................................3-49
Output the Setting List .............................................3-50
Output the received data by the ASCII code [ASCII
DUMP] .....................................................................3-51
Set the configurations with a computer ...................3-52
Make the media without uncut area ........................3-54
Select the number of pinch roller to use ..................3-56
Setting the FEED OFFSET .....................................3-57
Setting the FEED SPEED .......................................3-58
Setting the PRE FEED ............................................3-59
Set the network .......................................................3-61
Setting event mail function ......................................3-63
Miscellaneous Settings ......................................... 3-74
Switch the display language ....................................3-74
Switch the User .......................................................3-75
Other Convenient Settings ......................................3-76
Copy the set value from the other user setting. ......3-84
Reset the setting values to the initial state. .............3-85
CHAPTER 4 In Case of Trouble
Before taking a phenomenon as a trouble .............. 4-2
Troubles for which error messages are given on the
LCD ........................................................................ 4-4
Error message ...........................................................4-4
Status message ........................................................4-7
CHAPTER 5 Appendix
Specifications of the main unit ................................ 5-2
Repeatability condition ..............................................5-3
Cutter blade ............................................................ 5-4
Replacing the cutter ..................................................5-4
Adjusting the cutter blade ..........................................5-4
Replacing the cutter other than supplied one ............5-5
Adjusting blade edge of cutter other than supplied one
5-5
Note slip ................................................................. 5-6
To Next Page
Loading...
