5-9
5
2
Chapter 5 Maintenance
3
Press to select “CUSTODY
WASH”, and press the key.
• The carriage will move onto the platen.
4
Clean the wiper and the bracket.
(1) Open the front cover then pull out it by
holding projections at both ends of the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in cleaning solution for
maintenance. (SPC-0369: for solvent ink /
SPC-0137: for sublimation dye ink)
Wipe off so that cleaning solution for
maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
5
Press the key.
6
Clean the cap rubber.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
• Wipe off so that maintenance solution for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
7
Press the key.
8
Fill up the cap with cleaning solution for
maintenance．
• If the cleaning solution cartridge is not usable,
suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
9
Press the key.
10
Press to set the time for the
cleaning solution to be left as it is.
• Set Value:1 to 99 min (by the unit of 1 min)
11
Press the key.
• The nozzles are washed.
• When the nozzles have been completely washed,
the head moves to the maintenance position.
• Until wiper/ bracket cleaning is competed,
“COMPLETED” is displayed on the screen. After
the work up to the step 3 is completed, press the
[ENTER] key. If you press the [ENTER] key
before cleaning is completed, the machine moves
to the next washing procedure.
• Until wiper cleaning is competed, [COMPLETED
(NEXT): ENT] is displayed on the screen. After
the work up to the step 5 is completed, press the
[ENTER] key. If you press the [ENTER] key
before cleaning is completed, the machine moves
to the next washing procedure.
• Until washing liquid is filled, [COMPLETED
(NEXT): ENT] is displayed on the screen. After
the work up to the Step 8 is completed and you
close the front cover, press the [ENTER] key. If
you press the [ENTER] key before washing liquid
is filled, the carriage returns to the original
position.
To Next Page
Loading...
