MIMAKI CJV150-130 - Chapter 4 Cutting Funcion; Cut out Data with Registration Mark; The Flow of Cutting out the Registered Data; Precautions in Inputting Data with Registration Marks

Chapter 4 Cutting Funcion
4-2
Cut Out Data with Reg-
istration Mark
Create registration marks on an output image that you
want to make a seal, and the machine detects them to cut
it out.
There are following two types of registration marks.
The Flow of Cutting out the Regis-
tered Data
Enter the registration mark detection
mode
1
Press the
(TEST CUT)
in LOCAL.
2
Press to select the “MARK
DETECTION”, and press the key.
• It turns out to be a registration mark detection
mode.
Precautions in inputting data with
registration marks
There are some limitations on preparing data with
registration marks.
In order to make full use of this function, read the following
instructions carefully and prepare data with registration
marks properly.
Size of the registration marks
The registration mark length shall be about more than ten
times the line width.
In addition, for the length of a side of the registration mark
against the data, refer to “The size of, and the distance
between, registration marks” ( P.4-4).
• Use the TP4 when performing trapezium
compensation to correct the uneven sheet feeding
rate caused by the difference in the diameter
between the right and left grit rollers. If the
trapezium compensation is to be omitted, there is
no need to set the TP4. In that case, however,
cutting distortion will increase.
Registration mark: Type 1
Registration mark: Type 2
Add registration marks on the
image that you want to make a
seal and others, and print it on
a sheet.
Set the printed sheet in
CJV150 series.
Send the cut-target image from
the computer for cutting.
There are some
conditions for creating
the registration marks.
See pages P.4-2
through P.4-5.
Set it referring to
P. 2- 4.
In case it is not
successfully cut,
• Confirm the reaction
of registration mark
sensor.
• Confirm the position
of the Light Pointer.
• When the registration detection is set to OFF, it
doesn’t enter into the registration mode.
(P.4-6)
• While various functions are under setting, data
entry may be cancelled and the machine may go
back to the previous setting item.
• The registration mark described here is intended
to detect the sheet inclination and the lengths
along the X and Y axes. It is not a mark for
trimming.
0.5~2.0mm
4~40mm