4-3
Chapter 4 Cutting Funcion
4
2
2
The area where registration marks and
designs can be arranged
• The TP1 starting position must be 20 mm or more away from
the leading edge of the sheet.
• The TP2 end position must be 45 mm or more away from the
tail end of the sheet.
Mark Form : Type 1
Mark Form : Type 2
No-plotting area around the
registration marks
An area around a registration mark (from the mark origin
to the mark size area) is a non-plotting area. There must
be no data plotted or stain in this area; otherwise, a wrong
origin may be detected or a mark read error can occur.
• If a wrong mark origin is detected, the cutting will
be performed in a wrong area.
To Next Page
Loading...
