MIMAKI CJV150-130 - Page 92

4-12
Chapter 4 Cutting Funcion
Set the X direction (feeding direction)
DIVISION CUT
If the data size of the feeding direction exceeds the
division length and cross cut length, the machine cuts it at
that position by dividing it.
If the cross cut length is set, the machine cuts by
overlapping it by the set value.
1
Press the
(MENU) (>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the “SETUP SUB
MENU”, and press the key.
4
Press to select the “DIVISION
CUT”, and press the key.
5
Press to select “X”, and press
the key.
• If you select “OFF”, setting for division cutting will
not be carried out. Proceed to step 10.
6
Press to select “DIV. LENG”, and
press the key.
7
Press to select a set value, and
press the key.
• Set value : 50cm to 500 cm (in increments of
50cm)
• When it exceeds the set value, the machine cuts it
at that position by dividing it.
8
Press to select the “CROSS
CUT”, and press the key.
9
Press to select a set value, and
press the key.
• Set value : 0mm to 50mm (in increments of 1mm)
• The machine cuts by overlapping it by the set
value.
10
Press the key several times to
end the setting.
Reset the setting for DIVISION CUT
1
Press the
(MENU) (>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the “SETUP SUB
MENU”, and press the key.
4
Press to select the “DIVISION
CUT”, and press the key.
5
Press to select “Setting”, and
press the key.
6
Press to select “OFF”, and press
the key.
7
Press the key several times to
end the setting.
• The setting values are kept in memory even when
the power is turned off.
• During execution of division cutting, the machine
ignores any other data sent from the host
computer.
• In any of the following cases, the machine cannot
perform division cutting.
The data size is larger than the receiver buffer
capacity.
An origin change command is contained in the
cutting data.
A two-point compensation value has been set.
The registration mark detection is being
performed.
The machine cuts the test data stored in it.