4-16
Chapter 4 Cutting Funcion
Detect operation
1
Scan in the X direction (plus direction) to
detect the line.
• The buzzer sounds when the line is detected. If
the line is not detected, the buzzer does not
sound.
2
Scan in the X direction (minus direction) to
detect the line.
3
Scan in the Y direction (plus direction) to
detect the line.
4
Scan in the Y direction (minus direction) to
detect the line.
5
Follow the Steps 1 to 4, and confirm if the
buzzer sounds 4 times.
• When the detection behavior completes
successfully, the buzzer sounds 4 times.
• If the buzzer does not sound, contact our sales
office after checking the registration mark
condition.
Correct the light pointer position
If the machine fails to recognize any registration mark
properly, the possible cause is an error in the positional
relationship between the MARK sensor and the light
pointer.
In this case, adjust the position of the light pointer.
1
Install a cutter in the tool holder.
2
Load the copy paper.
3
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
4
Press
(>>)
.
5
Press to select the
“MAINTENANCE”, and press the
key.
6
Press to select “MARK
SENSOR”, and press the key.
7
Press twice to select “POINTER
OFS”.
8
Press the key.
• A 10 mm by 10 mm cross pattern will be cutted.
• The light pointer turns on and moves to the center
of the cross pattern.
9
Press to adjust the light
pointer position so that the center of the
light pointer is in alignment with the center
of the cross pattern.
10
Press the key.
• The machine will return to the local after
registering the compensation value.
To Next Page
Loading...
