Other Settings
4-39
4
Extended Functions – Cutting –
About Over Cutting
Specify whether the over cutting function is enable or unable and the
length of the over cutting.
If the length of the over cutting is set, cutting is performed with extra
cutting space at the front by the specified amount of length at the start
of cutting and tool up is performed at the end going too far.
• With setting the over cutting properly, you can reduce the part remaining uncut at
the start/end of the cutting, especially for the medium easy to bend. However,
too much amount of over cutting causes to scratches on the medium.
To Next Page
Loading...
Need help?
General