2-41
Head Cleaning
2
Basic Operations
8
Slowly shake the removed ink cartridge more than twenty times right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels.
Then, shake it more than twenty times right and left so that ink flows inside the cartridge.
9
Press the key.
10
Set the cartridge.
• After the cartridge is set, filling starts.
• When filling is completed, the screen returns to LOCAL.
About warning message display of performing spot color maintenance
When silver ink or white ink of ES3 ink is used and when ink has been left for two
days and more without being used, to prevent color heterogeneity due to settling
down of pigment, the message on the right is displayed on the screen.
The warning message is displayed when you turn on the power sup-
ply after two days has passed from the silver ink had been used last
time.
Silver ink and white ink change their colors if they have been left for
about two days.
If the warning message is displayed, perform special color mainte-
nance by following the procedures below:
1
If the warning message is displayed, press the key.
• If you do not wish to perform spot color maintenance, press the key to cancel the operation.
2
Press the key.
• If you shake it too strong, the pack inside may be damaged and it may cause ink
leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt
the cartridge until it becomes vertical.
To Next Page
Loading...
Need help?
General