MIMAKI UJF-3042 MkII Series - Setting and Adjusting the Media

Chapter 2 Basic Operation
2-4
[END/POWER] key a long time on the front of the
machine, check the display is turned off on the
operation panel, and then turn the main power switch
off.
Setting the media
1
Setting the media thickness.
(1) Press the [FUNC1] (MENU) [] (1 time)
[ENTER] key in LOCAL mode.
(2) Select “MEDIA THICKNESS”, and press the
[ENTER] key.
(3) Press [][] to set the media thickness, and
press the [ENTER] key.
Setting the Table Height
If the table height is changed, Media Thickness is also
changed.
1
Press the (MENU)
[] key in LOCAL mode.
• HEAD HEIGHT MENU will be displayed.
2
Press to serect “TABLE
HEIGHT” , and press the key.
3
Press to set the table height,
and press the key.
Set value : 0.0 to 153.0mm
4
Press the key several times to
end the setting.
• The peripheral parts of the media could roll up due
to heat. Fix the media supplementary using
adhesive tapes, etc.
• When using a jig, enter the jig's height + the media
thickness.
• Place the media so that concentrated load is
prevented.
• The value to be entered varies by the number of
table spacer.