MIMAKI UJF-3042 MkII Series - Network and Event Mail Setup

3-19
Chapter 3 Setup
3
2
2
2
Setting the network
1
Press the
(MENU) (>>)
key local mode.
• MACHINE SETUP MENU will be displayed.
2
Press to select “NETWORK” ,
and press the key.
3
Press to select “CHECK IP
ADDRESS” , and press the key.
• The IP address currently used by this machine is
displayed.
• When you have finished the check, press the
[ENTER] key.
4
Press to select “CHECK MAC
ADDRESS” , and press the key.
• The MAC address currently used by this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
5
Press to select “DHCP” , and
press the key.
6
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is "ON", the IP address given by the
DHCP server is used.
7
Press to select “AutoIP”, and
press the key.
8
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is "ON", the IP address is determined by
the AutoIP protocol. However, DHCP is "ON",
DHCP has priority.
9
Press to select “IP ADDRESS” ,
and press the key.
10
Press to select a set value, and
press the key.
11
Press the key several times to
end the setting.
Setting event mail function
Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
Enable the event mail function
1
Press the
(MENU) (>>)
key in LOCAL mode.
• MACHINE SETUP MENU will be displayed.
2
Press to select “EVENT MAIL” ,
and press the key.
3
Press to select “MAIL
DELIVERY” , and press the key.
4
Press to select “ON”, and press
the key.
5
Press the key several times to
end the setting.
• After connecting with the network, it takes time
until the IP address is determined. If the IP
address has not been determined, “0.0.0.0” is
displayed.
• To reflect network setting, once turn off the power
supply and turn it on again.
•Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.