MIMAKI UJF-3042 MkII Series User Manual

This chapter
describes the items required to use this machine more comfortably, which are the methods for the daily
care, the maintenance of the ink bottles etc.
Routine maintenance................................... 4-2
When this machine is left unused for a long time
4-2
Precautions in cleaning .............................. 4-2
Cleaning exterior surfaces ......................... 4-2
Cleaning the table ...................................... 4-2
About MAINTENANCE MENU..................... 4-4
MAINTENANCE MENUs at-a-glance......... 4-5
Maintaining the Capping Station .................. 4-6
Cleaning the Wiper and Cap ...................... 4-6
Cleaning the mist filter................................ 4-8
Nozzle Wash .............................................. 4-9
Nozzle Wash (When PR-200 ink using)... 4-10
Washing the Ink Discharge Passage ....... 4-11
When the Machine Is Not Used for a Long Time
4-12
Sub tank maintenance ............................. 4-13
White maintenance .................................. 4-13
Cleaning the Ink Head and the Area around It4-
14
Clean the bottom of the LED lamp and the bot-
tom of the mist filter.................................. 4-14
Nozzle Recovery Function..................................4-15
Reset the set value .................................. 4-16
Checking the UV Lamp Usage .................4-16
Solving the Ink Overflow Problem.............4-17
Automatic Maintenance Function...............4-17
Setting the Refreshing Intervals................4-18
Setting the Cleaning Intervals and Type... 4-18
Replacing consumables .............................4-18
(When using rubber wiper) Replace the wiper/
wiper absorber..........................................4-18
(When using suction wiper)Replace the nozzle
cap............................................................4-19
Replacing the mist filter ............................4-19
If a Waste Ink Tank Confirmation Message Ap-
pears.........................................................4-20
Replacing the waste ink tank before the waste
ink tank confirmation message is displayed4-21
If Check Wiper Waste Inktank Warning Appears
4-22
Replacing the waste ink tank before the “Check
wiper waste inktank” warning is displayed 4-23
Supplying antifreeze liquid .........................4-23
Supplying antifreeze liquid........................4-24
Chapter 4
Maintenance

MIMAKI UJF-3042 MkII Series Specifications

General

Maximum Print Size	300 x 420 mm
Power Supply	AC100-240V, 50/60Hz
Print Technology	UV LED
Ink Type	UV curable ink
Interface	USB 2.0, Ethernet
Ink Colors	C, M, Y, K, W, Cl
Media Weight	Up to 5 kg
Resolution	Up to 1200 x 1200 dpi