MIMAKI UJF-3042 MkII Series - Nozzle Wash (When PR-200 Ink Using)

Chapter 4 Maintenance
4-10
Nozzle Wash (When PR-200 ink
using)
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “ MAINTENANCE ”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press the key.
• “STATION” will be selected.
4
Press , and press the key.
• “NOZZLE WASH” will be selected and the
carriage will move.
5
Open the maintenance cover on the station
side.
6
(When using rubber wiper) Clean the wiper
and bracket.
• Perform Step 7 when using the suction wiper.
(1) Open the right maintenance cover then pull out it
by holding protrusions at both ends of the wiper.
(2) Include F-200 / LF-200 maintenance liquid
in the clean stick and clean.
• Wipe off F-200 / LF-200 maintenance liquid
so that no maintenance liquid remains.
(3) Insert it in the original position by holding the
protrusions at both ends of the wiper.
7
(When using suction wiper) Clean the
suction wiper and around the wiper.
• Include F-200 / LF-200 in the clean stick and
clean.
• Wipe off F-200 / LF-200 maintenance liquid so
that no maintenance liquid remains.
• On models equipped with the PR-200, ink may
clog the nozzle. Please check the Ver. on the label
of the PR-200 ink cartridge, pack, or bottle, and
clean the nozzle. Please clean the nozzle twice a
week for Ver.2 and once a month for Ver.3.
[Label Ver. notation position]
• 220ml Cartridge
• 250ml Bottle
• 600ml Pack
• 1L Bottle
Maintenance liquid required
• F-200 / LF-200 maintenance liquid (SPC-0568)
• PR-200 cleaning solution
(C-ML013-Z-B2-1-KW)
Protrusion
Suction wipe
Area around wiper
Area around wiper
Suction wipe
UJF-3042MkII/3042MkII EX
/6042MkII
UJF-3042MkII e/3042MkII EX e
/6042MkII e