MIMAKI UJF-3042 MkII Series - Checking the UV Lamp Usage; Reset the Set Value; Solving the Ink Overflow Problem

Chapter 4 Maintenance
4-17
1
2
2
4
5
6
Reset the set value
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “ MAINTENANCE ”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press to select “NOZZLE
RECOVERY”, and press the key.
4
Press to select “Reset”, and
press the key.
5
Press and
(>>)
(<<)
to selet theNozzle line that
need reset, and press the key.
• A reset confirmation message will be displayed.
6
Press the key several times
to end the setting.
Checking the UV Lamp Usage
Checking Uv Lamp Use Time
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “ MAINTENANCE ”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Select “UV USED TIME”, and press the
key.
• The use time is displayed for each of the UV
lamps.
4
Press the key several times to
end the setting.
Solving the Ink Overflow Problem
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “ MAINTENANCE ”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press the
(<<)
.
4
Press to select “Overflow” , and
press the key.
5
Press to select head.
6
Press the key.
7
Press the key several times to
end the setting.
• Repeat this procedure if you cannot solve the
problem after performing it once.
If you still cannot solve the problem even after
performing this procedure three times, contact
your local distributor, our sales office, or service
center.