Chapter 4 Maintenance
4-26
Precautions in handling the antifreeze liquid
Supplying antifreeze liquid
If an error of lack of water occurs, supply antifreeze liquid.
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “Maintenance”,
and press the key.
• MAINTENANCE MENU will be displayed.
3
Press to select “Water FillUp”,
and press the key.
4
Press the key.
• Water flow stops.
5
Open the left maintenance cover.
6
Disconnect the right end of the tube
connected to the feed-water inlet.
• Indicated with "IN" label.
7
Made mixed liquid (antifreeze liquid: 1,
water: 2) in the attached reservoir and
move it to the attached syringe.
• Be sure to wear the included safety glasses and
gloves for handling the antifreeze liquid.
• Use the recommended antifreeze liquid by
Mimaki. If not, the cooling device may be broken.
(Supplied antifreeze liquid :1000cc x 2 bottles)
• Do not touch the antifreeze liquid directly. If the
antifreeze liquid settles on your skin or clothes,
immediately wash it off with soap and water. If you
get antifreeze liquid in your eyes, immediately
wash your eyes with a lot of clean water. Then,
consult a doctor as soon as possible.
• Store antifreeze liquid in a dark and cold place.
• Store antifreeze liquid in a place that is out of the
reach of children.
• When discarding antifreeze liquid which is no
longer needed, entrust them to an industrial waste
disposal contractor, clarifying their contents.
• Before using antifreeze liquid, be sure to read the
Safety Data Sheet (SDS).
• Prepare a tank with a cap to put in the waste water
from cooling water tank.
• When water in the cooling water tank is low, a
warning message “WATER LACK” is displayed. In
this case, refill antifreeze water in the way shown
as the next page.
• Pay attention while handling the tube as antifreeze
liquid flowing in it is hot.
• Make sure that water flow has stopped in Step 2.
To Next Page
Loading...
