MIMAKI UJF-3042 MkII Series - Page 67

3-21
Chapter 3 Setup
3
2
2
2
Set the server
1
Press the
(MENU) (>>)
key in LOCAL mode.
• MACHINE SETUP MENU will be displayed.
2
Press to select “EVENT MAIL” ,
and press the key.
3
Press to select “SERVER
SETUP” , and press the key.
4
Press to select “SMTP
ADDRESS” , and press the key.
5
Press to set SMTP
Address, and press the key.
• Press the jog key [][][][] to set SMTP
address.
• Input the SMTP address name.
• Set it with alphanumeric characters and symbols
within 40 characters.
6
Press to select “SMTP PORT
No.” , and press the key.
7
Press to set SMTP Port No., and
press the key.
• Set the SMTP port number.
8
Press to select “SENDER MAIL
ADDR” , and press the key.
9
Press to set SENDER
MAIL ADDRESS, and press the
key.
•Press [][][][] and set the e-mail address to
be used as the sender mail address.
• Set it with alphanumeric characters and symbols
within 64 characters.
10
Press to select
“AUTHENTICATION” , and press the
key.
11
Press to set authentication
method, and press the key.
• Set the authentication method of the SMTP
server.
• When you select [OFF], proceed to the Step 20.
12
Press to select “USER NAME” ,
and press the key.
13
Press to set User Name,
and press the key.
•Press [][][][] to set the user name to use
for the authentication.
• Set it with alphanumeric characters and symbols
within 30 characters.
14
Press to select “PASSWORD” ,
and press the key.
15
Press to set Pass Word,
and press the key.
•Press [][][][] to set the password to use for
the authentication.
• Set it with alphanumeric characters and symbols
within 15 characters.
• When you select [POP before SMTP] in the Step
9, set the items in the Step 14 to 17.
16
Press to select “POP3
ADDRESS” , and press the key.
17
Press to set POP3
Address, and press the key.
•Press [][][][] to set POP server.
• Input the POP server name.
• Set it with alphanumeric characters and symbols
within 40 characters.
18
Press to select “APOP” , and
press the key.
19
Press to set ON/ OFF, and press
the key.
20
Press the key several times to
end the setting.
• Depending on your server, if you do not
set the e-mail address not supporting the
account, sending/ receiving e-mails may
be unavailable.
• On the password setting screen, you can
only check the value that you are
currently inputting.